Guest
Show Posts
1
General Mach Discussion / Digitize led keeps flashing
« on: May 05, 2015, 07:49:15 AM »
Hello all:
I am trying to setup the tool centering and the zero plate scripts. I am using Mach3 under windows 7 32 bit. I have the probe on pin 13(i also tried 15) with active low.
The digitize led is for the most part off, however it randomly flashes. I have change the debounce setting to the point where the led is mostly off, however when i run the center routine, i have the debounce settings so high that the script over shoots the contact point. Any help would be appreciated. Thanks. Steve.
I am trying to setup the tool centering and the zero plate scripts. I am using Mach3 under windows 7 32 bit. I have the probe on pin 13(i also tried 15) with active low.
The digitize led is for the most part off, however it randomly flashes. I have change the debounce setting to the point where the led is mostly off, however when i run the center routine, i have the debounce settings so high that the script over shoots the contact point. Any help would be appreciated. Thanks. Steve.