11
General Mach Discussion / Ethernet Smooth Stepper Problems - Stops at the same place EVERY time
« on: April 30, 2015, 10:01:29 AM »
I am running Mach3 with a smooth stepper on an old Dell Latitude Computer using XP. I am trying to do some 3d milling. When milling a piece of code that is short I do not seem to have problems. But on longer programs used for 3d milling it just stops with the "ran out of data" message.
I have run the special driver program, I have updated my computer to have 4 gig. of ram.
I don't think it is a windows interupt issue because it stops at the same line of code everytime, Line number #238226. I have the look ahead set to 225.
Clueless where to look
I have run the special driver program, I have updated my computer to have 4 gig. of ram.
I don't think it is a windows interupt issue because it stops at the same line of code everytime, Line number #238226. I have the look ahead set to 225.
Clueless where to look