Hello Guest it is April 20, 2024, 02:55:04 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - hamitduk

Pages: 1
1
Hi

just got a USB Cam and it comes back with a VideoOCX 24 bits color depth error, I have looked thru the forum and it has been discussed, but there seam to be a void between "I have this problem" and "It works better now"

I loaded the plugin V3 and it shows up in there but Mach3 farts at me every time.

Help please

it is Win 7 Pro.

Hami

2
HI again,

Ok I go it all back together and made a a few test passes (no spindle motor in place), looked great, and on the last pass, headed for home, the X axis started to shutter back and forth, Help?

 Testing moved, moved motor feed to other Steeper driver, problem fallowed, the setup was the same on both drivers, if I disconnect the motors and short them it loads up, disconnected it if free runs.

what more info do you need?

I will be waiting baited breath!

Hami

3
I have read the manual and can't fine how to use the GOTO button.

I have gotten to the point, hit the GOTO button, touch a axis, type in location, what is next?


4
Hi

Are there any USB reliable USB controllers for Mach3?


5
General Mach Discussion / Video requirements?
« on: May 03, 2015, 07:03:19 PM »
Hi,

What about a USB Video devices, do they meet the requirements of M3/4?

D

7
Hi,

I had two 5045 stepper controllers go bump at the same time.

they will come live, green LED, as soon as I put a load, any movement command, they pop over to red.

does anybody have a fix/repair

they were running at 48VDC at 3amp, motors Nema24 4.2 N.m

8
Hi,

Help, Help, Help!

Mach3, load a G-code file and the motor tuning numbers stay the same, but if I recheck the Z it goes from what was a .5" on the DRO to .06xx", for .5" on the Dial indicator.

File created in SW2015, exported to DFX, into HSM.

system:
Win 7 86, 4 gig Ram, 250gig HD, 3070 CPU, Syba Parallel card

It is altered before here.

(BOTTOM BASE G4)
(MACHINE)
(  VENDOR NONE)
(  MODEL DUK)
(  DESCRIPTION OXY MORON)
(T1  D=0.25 CR=0. - ZMIN=-0.1375 - FLAT END MILL)
G90 G94 G91.1 G40 G49 G17
G20
G28 G91 Z0.
G90

(2D POCKET3)
M5
M9
T1 M6
(2 FLUTE FLAT ENDMILL)
S5000 M3
G54
M8
G0 X0.8801 Y0.1802
G43 Z0.6 H1
Z0.2
G1 Z0.125 F20.
G3 X0.8793 Y0.1811 Z0.1174 R0.1188
X0.8772 Y0.1838 Z0.1106 R0.1188
X0.8738 Y0.1878 Z0.1051 R0.1187

Help, Help, Help, Thanks


Pages: 1