Hello Guest it is March 28, 2024, 06:34:10 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ax2015

Pages: 1
1
General Mach Discussion / Re: New versions and Feed hold bug
« on: April 27, 2015, 08:18:30 AM »
Hello. I knew that pressing Stop (after FeedHold) makes RFH to work properly. Just that it disables motors and exact positions are lost. So, the answer is probably: there is no equivalent way to use Feed Hold+Cycle start and Feed Hold+RFH. Thats fine as long as FeedHold+Cycle start really works. (and it seems to work now with .062).

Ax

2
General Mach Discussion / Re: New versions and Feed hold bug
« on: April 26, 2015, 12:44:21 PM »
Downgraded to .62 and Feed Hold seems to work now (at least during one mill)
Run From Here seems to work somehow differently between .062 and .066.
I'm trying to use Feed Hold+Run From Here similar way than Feed Hold+Cycle start:

1. press Feed Hold
2. do your stuff
3. Press Run Frome here
4. <pointer returns to line nr 1!>

How can I continue program using Feed Hold + Run From Here?
As far as I remember, I used the method above with .066

Ax


3
General Mach Discussion / Re: New versions and Feed hold bug
« on: April 23, 2015, 06:12:23 AM »
Hello,
Thanks for your prompt reply. So there are known issues with the latest versions?

Axel

4
General Mach Discussion / New versions and Feed hold bug
« on: April 22, 2015, 04:05:41 PM »
Hello. Been using Mach3 for a while and few times router has done something very weird. Today I experienced major crash using this sequence:
- while running gcode, press Feed hold
- move Z up to clear bit
- press Cycle start to continue

This should be a standard procedure and also described on manual. What happened was a move to an unknown position which caused a crash of course. There is a video on Youtube about the same procedure - and about the same crash...

I have .066 version. Any plans to fix those bugs since Mach3 hasn't gotten any updates since long time?
I have read posts about .067 dev version. Worth downloading (and from where)?

Axel

Pages: 1