Messages

11

General Mach Discussion / Cycle Jog Step/Jog Mode not working

« on: April 06, 2015, 06:31:32 AM »

  I am just starting out with Mach3/cnc stuff and at a loss.

 If I press TAB the MPG MODE come on. If you look at the Jog Mode (no light). Cycle Jog Step will not move through the steps in the Gen config. Key board will jog only in motor setup.

I have some more question on getting this thing started//running.

 Like the homing. grrrrr.  But one thing at a time. I have one of those TB6560 4V3 boards. I had to jump wires from where the parallel port is first connected to the board.  20 to com, 10 to LPT10, 11 to LPT11, exc..... Now the limit switches, Estop and probe are working.

Regards
Gizmo