Messages

1

Mach3 and G-Rex / Mach3 command for auto tool change torch and lazor marker, seperate jobs, pos

« on: April 06, 2015, 12:16:06 AM »

The lazer T1 will mark on the sheet, and the the hand can pick up the torch and start cutting, marking and cutting are 2 difference jobs without any related, i just want the lazor to create mark on the products that were cut out. And i dont know what code i should right in mach3 and macro, because there is a subtraction between coordinates of the torch and the lazer marker so there will be an off distances when it start, so the problem is at the coordinates of the tools.