Messages

11

VB and the development of wizards / Re: Run script when cnc cut finishes

« on: June 08, 2016, 03:33:51 PM »

I know this has been a long time since the last post, however, I've implemented this code and it works amazingly well. One question. Is there a way that Mach3 only runs the M1030 code AFTER the cut is complete? Presently, the code runs at the beginning and end of a cut, and also at the beginning and end of a simulation as well. I'd welcome any thoughts! (As I also wanted to 'park' the machine at the end of the cut, and didn't want it to park at the beginning as well.)

Thanks so much!