1
Mach4 General Discussion / Mach 4 Tool Auto Zero
« on: March 07, 2015, 05:35:15 AM »
I was trying to figure out a few things regarding tool auto-zero in Mach 4.
1. When the M6 code comes up when running a program it passes by the code as if it is a comment, NO it does not show up as (M6) in code. no brackets.
2. I see the button for tool auto-zero on the main "run Program" page, but alas, nothing comes of it when pressed.
I am new to Mach 4 so I am %99.99 SURE I missed something somewhere!
P.S. also what is the best recommended wiring for the touch-off plate, I plan on having one for tool change permenantly installed on the table.
Any and all help given is more than greatly appreciated.
V/R
Mike (it*guy)
1. When the M6 code comes up when running a program it passes by the code as if it is a comment, NO it does not show up as (M6) in code. no brackets.
2. I see the button for tool auto-zero on the main "run Program" page, but alas, nothing comes of it when pressed.
I am new to Mach 4 so I am %99.99 SURE I missed something somewhere!
P.S. also what is the best recommended wiring for the touch-off plate, I plan on having one for tool change permenantly installed on the table.
Any and all help given is more than greatly appreciated.
V/R
Mike (it*guy)