11
General Mach Discussion / Tool Data table randomly changes between lathe and mill tools
« on: February 23, 2015, 12:39:59 AM »
Warning. I have a reputation for eliciting computer output that defies any logical result of the input. I have a vexing problem right now with my current project.
I am running a small lathe and am using the Mach3 1024.lset screen. I have version R3.043.066 Mach3. When I launch a profile from the Loader I randomly have either lathe tools or milling tools showing in the Tool Table Editor. Both tables show lathe tool inserts in the Tool column. I have tried several profiles from third party bob vendors and the problem seems to occur with all combinations of profiles and lathe screen sets I have tried.
Would appreciate any ideas on where to look for a solution.
Thanks,
Aruminat
I am running a small lathe and am using the Mach3 1024.lset screen. I have version R3.043.066 Mach3. When I launch a profile from the Loader I randomly have either lathe tools or milling tools showing in the Tool Table Editor. Both tables show lathe tool inserts in the Tool column. I have tried several profiles from third party bob vendors and the problem seems to occur with all combinations of profiles and lathe screen sets I have tried.
Would appreciate any ideas on where to look for a solution.
Thanks,
Aruminat