Hello Guest it is April 17, 2024, 11:16:17 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - metalartmom

Pages: « 1 2
11
Mach Screens / Re: Mach 3 Main screen Diagnostics
« on: February 23, 2015, 01:00:49 PM »
Did you ever get an answer to your question. I have the same problem only it is pin one that will not light up and I can not find anyone who does plasma to help me

12
I cloned my info from my old computer and had to purchase mach3 (had it on my old computer) matched up all my old settings but can not get the torch to lower when I try to cut. I had to change the bio's to the correct parallel port but now on the diag. page Pin 1 light (in the row of 12 lights)  will not come on. Everything else move correctly and the torch will fire it just will not lower down. Any suggestions? I can do basics with computer lingo but if you start tossing out all advanced terminology I will be lost. I have a Gecko 540 that I connect to. My computer is a gaming computer so there is no name for it and it runs with an intel processor.
Thank for any help you can give me.

Metalmom

Pages: « 1 2