11
General Mach Discussion / Mach3 Windows 7 64bit with UC100- NEED HELP!!!
« on: February 12, 2015, 09:37:52 PM »
I am running Mach3 on windows 7 64 bit. I have a UC 100 motion controller. Everything is wired according to the wiring diagram. I cannot get a motor to turn during testing. The computer is connected to the UC 100. I have voltage at the signal side of the motor driver when I press the keyboard buttons to move the axis.
I am not sure what I am doing wrong but I cannot get the motor to turn with anything I try.
Please Help!
I am not sure what I am doing wrong but I cannot get the motor to turn with anything I try.
Please Help!