Messages

11

General Mach Discussion / Re: Trouble moving from XP to Win7 32bit

« on: January 28, 2023, 06:17:29 AM »

Can you give us some info on your  Break out board or what ever connects the parallel port to the stepper drivers?

12

General Mach Discussion / Re: PWM bumped to minimum setting

« on: January 21, 2023, 01:21:03 PM »

Yea you are controlling voltage by controlling the on time compared to the off time thus creating a voltage value form 0 max voltage making a digital signal analog.

13

General Mach Discussion / Re: PWM bumped to minimum setting

« on: January 21, 2023, 06:49:29 AM »

but PWM is not a 0-10V signal

I will have to disagree with that statement.

With the vfd being used  uses 0-10 volts at a given frequency  to control spindle rpm if the correct parameters are set in the vfd.

14

General Mach Discussion / Re: Thinking of AXBB-E ethernet motion controller

« on: January 07, 2023, 05:33:32 AM »

how about something like this: https://www.cncdrive.com/UC300ETH.html

15

General Mach Discussion / Re: Why has my CNC stopped working? Need help please.

« on: November 30, 2022, 04:59:22 AM »

 you could try to power up everything and then look at the diagnostics page in mach3 and see if you see anything going on.

16

General Mach Discussion / Re: Mach 3 Job Size problem. Help Please??

« on: November 23, 2022, 07:42:01 PM »

Yes they are. Press the tab key again to close the jog panel.

17

General Mach Discussion / Re: Mach 3 Job Size problem. Help Please??

« on: November 23, 2022, 07:10:09 PM »

Stupid spell check. I ment to say press the tab key.

18

General Mach Discussion / Re: Mach 3 Job Size problem. Help Please??

« on: November 23, 2022, 07:09:20 PM »

I mentioned the tab key.

19

General Mach Discussion / Re: Mach 3 Job Size problem. Help Please??

« on: November 23, 2022, 07:08:55 PM »

Hit the table key on the key board and you can set the step increment.

20

General Mach Discussion / Re: Mach 3 Job Size problem. Help Please??

« on: November 23, 2022, 05:22:14 AM »

Hi Ronnie,
  Glad to see you got it working. I was unable to pm you last night due to the forum was having issues and I could not log in.
regards
Charlie