Guest
Show Posts
1
General Mach Discussion / Homing/limit switches
« on: May 10, 2016, 02:54:07 PM »
Hello,
A few weeks ago I turned on my machine hit Ref. home z went up and did not stop. No signal to switches X,Y or Z.
I could still jog all the Axis and also run the machine just could not Ref. Home.
I thought it might be the motion card I have leafboy77 in my machine.
I bought a new board ( mach3 motion card) but had not installed it yet.
Yesterday I turned on the machine hit Ref. Home Z got a signal and so did Y but not X.
Went to home depot came home hit Ref. Home and wow all three switches got a signal.
Thought all was good.
Turned on the machine this morning and no signal on any of the switches.
Is my problem Mach3 or is it the motion card?
Thank you,
Philip
A few weeks ago I turned on my machine hit Ref. home z went up and did not stop. No signal to switches X,Y or Z.
I could still jog all the Axis and also run the machine just could not Ref. Home.
I thought it might be the motion card I have leafboy77 in my machine.
I bought a new board ( mach3 motion card) but had not installed it yet.
Yesterday I turned on the machine hit Ref. Home Z got a signal and so did Y but not X.
Went to home depot came home hit Ref. Home and wow all three switches got a signal.
Thought all was good.
Turned on the machine this morning and no signal on any of the switches.
Is my problem Mach3 or is it the motion card?
Thank you,
Philip