Hello Guest it is December 10, 2019, 02:13:39 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dukie94

Pages: 1
1
General Mach Discussion / Re: Homing/limit switches
« on: May 10, 2016, 09:51:55 PM »
Thank you for responding!!!
I have tested the all connection with the meter many times
and checked for lose wires twice as much.
I think it may be Mach3.
normally in feed rate it should be 100 its 6.00
the Normal condition button is yellow in the past I would hit it
and it would turn green now when I hit it  a little box window
comes up and says
Warning: This will reset your monitoring to consider current conditions
as normal.
philip

2
General Mach Discussion / Homing/limit switches
« on: May 10, 2016, 02:54:07 PM »
Hello,
A few weeks ago I turned on my machine hit Ref. home z went up and did not stop. No signal to switches X,Y or Z.
I could still jog all the Axis and also run the machine just could not Ref. Home.
I thought it might be the motion card I have leafboy77 in my machine.
I bought a new board ( mach3 motion card) but had not installed it yet.
Yesterday I turned on the machine hit Ref. Home Z got a signal and so did Y but not X.
Went to home depot came home hit Ref. Home and wow all three switches got a signal.
Thought all was good.
Turned on the machine this morning and no signal on any of the switches.
Is my problem Mach3 or is it the motion card?
Thank you,
Philip

3
G-Code, CAD, and CAM discussions / Mach3 Cam/cad
« on: May 04, 2015, 03:15:53 PM »
I just bought a cnc machine. I need help setting up mach3.
How to convert from vectric to mach3?
Thank you,
Phil

4
General Mach Discussion / Re: new to cad cam more questions
« on: February 06, 2015, 08:24:19 PM »
Does anyone use JDPaint 5.5 or Type 3 with mach3?

Pages: 1