51
Mach4 General Discussion / Re: MACH 4 screen contrast
« on: December 02, 2019, 05:00:03 PM »
I can't get the line widths to change, any idea on what am I doing wrong?
Chuck
Chuck
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Hi,
I have not used it myself but there have been favourable reports from those who have:
https://www.machsupport.com/software/3d-cutting-simulator-moduleworks-plugin/
My understanding is that it is written by a third party company and they sell it to enhance Mach4. The cost is $50.
I suspect it would go a long way to satisfying your requirement of a more sophisticated toolpath simulator.
I am still happy with my two freeware viewers despite not being integrated into Mach.
Craig
Hi,
I have not used it myself but there have been favourable reports from those who have:
https://www.machsupport.com/software/3d-cutting-simulator-moduleworks-plugin/
My understanding is that it is written by a third party company and they sell it to enhance Mach4. The cost is $50.
I suspect it would go a long way to satisfying your requirement of a more sophisticated toolpath simulator.
I am still happy with my two freeware viewers despite not being integrated into Mach.
Craig