Guest
Show Posts
11
General Mach Discussion / starting a lubrication pump
« on: March 11, 2017, 08:01:56 PM »
Hi Group,
I'm looking for some help on how to send a signal that would start my spindle lubrication pump as soon as the spindles starts spinning.
This signal would energize a relay than would start a single phase 115vac KB Electronics VFD that generates 3 phase power for the spindle lub pump.
I'm running Mach3, ESS Motion control board and a C32s breakout board from CNC4PC.
I would think this is relatively straightforward for an experienced user, but unfortunately I'm still a novice.
Thanks for your help,
Chuck
I'm looking for some help on how to send a signal that would start my spindle lubrication pump as soon as the spindles starts spinning.
This signal would energize a relay than would start a single phase 115vac KB Electronics VFD that generates 3 phase power for the spindle lub pump.
I'm running Mach3, ESS Motion control board and a C32s breakout board from CNC4PC.
I would think this is relatively straightforward for an experienced user, but unfortunately I'm still a novice.
Thanks for your help,
Chuck