1
General Mach Discussion / Re: Mach3 Turn X axis problems
« on: January 01, 2021, 08:39:36 AM »
Found the problem. I needed to home the machine. Now it´s fine.
Homing seems to work fine, but when When I use G28 than it triggers the limit switches and I need to reset. Instead of G28 I end the program with G53 X-5 Z-5. + M30. Then it stop before it trigger the limit switches.
How should I go about using G28 whit out trigger the limit switch? Home and limit are combined.
Homing seems to work fine, but when When I use G28 than it triggers the limit switches and I need to reset. Instead of G28 I end the program with G53 X-5 Z-5. + M30. Then it stop before it trigger the limit switches.
How should I go about using G28 whit out trigger the limit switch? Home and limit are combined.