3
« on: March 15, 2009, 11:57:45 AM »
This is a little different than what ya'll are discussing, so please forgive. My machine came with a factory installed auto zero plate. When used it works. It tells me it is moving to a safe z height of 1" after zeroing the z. In reality it moves to over 4". After running my cut file, without problems, the z does not return to the proper height if I rerun the cut file. It is about 1" high. The dro reads 0 and if you run the cut file,it will cut 1" to high. No problems with this if I manually set z. What do I need to change? I have the lastest lockdown.
Kent