Messages

1

Mach4 General Discussion / Re: Mach4 Printer Port Discussions

« on: December 31, 2014, 03:40:35 PM »

Thank you Steve
I loaded Mach4 But I did not load Darwin.
Eric

2

Mach4 General Discussion / Re: Mach4 Printer Port Discussions

« on: December 31, 2014, 01:12:07 PM »

Hello Art,
How do I check to see if the license is activated. When I trying to set up Mach 4 just stops responding to jog mode and if it sit for a little bit, I have to restart Mach 4 to get it to work. Do you have any ideas.
Eric

3

Mach4 General Discussion / Re: Mach4 Printer Port Discussions

« on: December 22, 2014, 06:46:10 PM »

Hello Art,
Will Darwin run with Windows 7 32 bit.
I try and could not get it to install
Eric

4

Mach4 General Discussion / Re: Mach4 Printer Port Discussions

« on: December 20, 2014, 10:54:29 AM »

Thanks Art,
I guess that's not my problem.
I can get to run in 2D but when I try 3D it is very Jerky. I am working on a newer pc has  I type this
Thanks again.
Eric

5

Mach4 General Discussion / Re: Mach4 Printer Port Discussions

« on: December 19, 2014, 02:48:54 PM »

Hello Art
I am running Mach Build 2114 an Darwin 1.21 version 1.19
On your post #98 you said that if we were running both Mach 3 and 4 on the same computer we would need to have Veredist_86 installed.
If you did not have this on your computer would Mach 4 run Jerky or not at all.
Thank you
Eric