Hello Guest it is April 18, 2024, 07:21:16 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - wbrent7766

Pages: 1
1
General Mach Discussion / Re: Not finishing cut Help?
« on: December 15, 2014, 11:00:17 AM »
let's try this

2
General Mach Discussion / Re: Not finishing cut Help?
« on: December 14, 2014, 11:57:36 AM »
Here is a pic of my machine before the torch was added. Scatch built 54" X 54"

3
General Mach Discussion / Not finishing cut Help?
« on: December 13, 2014, 06:36:13 PM »
G-code through Sheetcam. Problem is that as soon as it scrolls to the M05 code (early)  the torch goes out, the machine finishes the movment and then goes on.  Anybody have this issue?

Pages: 1