Messages

11

CS-Lab / Re: Csmio/IP-A drives

« on: December 18, 2014, 06:04:44 AM »

Thanks starting to make sense.
Need to order drives and didn't
Want to make a big $ mistake.
Thanks for your help again. I
Will have plenty more questions
I'll sure.

12

CS-Lab / Re: Csmio/IP-A drives

« on: December 18, 2014, 05:39:50 AM »

The drives I was considering are AMC 25A20.
Think it can take both encoder and the tach.
So if I get this right I only have to run the encoder back to the ip/a And not use the tach at all.

13

CS-Lab / Re: Csmio/IP-A drives

« on: December 18, 2014, 04:43:32 AM »

Thanks hood.
 questions for the ip/a  should it be set up in torque mode?
Or velocity mode?
In torque mode the the feed back (encoders) go's to the ip/a
And not the drive is that right? And no tach is used
So in velocity mode encoders and the tach go's to the drives?
Little lost but trying to get my head rapped around it

14

CS-Lab / Re: Csmio/IP-A drives

« on: December 10, 2014, 07:40:33 PM »

Thanks guys will check them out.
 question how critical is the output vdc does it have to mach the motor (100vdc)
And the same for current cont. And the peak current.

15

CS-Lab / Csmio/IP-A drives

« on: December 10, 2014, 04:08:48 AM »

Ok guys getting ready to dive into my first cnc build.
The machine is a supermax ycm 30. With a old dynapath system 10. Servo are good but 1 of the drives are bad.
So to use ip/a I know I need the drives to be analog. That's were the problem starts I'm Having trouble finding drives for my motors. And will work with the ip/a.
Motor are Baldor. With encoders
100vdc.(but 1 says 150 max v) it was a replacement
Motor. The Baldor site says 100 vdc)
Current cont. 6.13
Peak current 24.7
Anyone have known of drives that will work?
Thanks