Messages

61

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 06, 2015, 08:13:22 AM »

I'm so sorry, please to check now..

62

General Mach Discussion / Vibration At Low Speed! Help please!

« on: February 06, 2015, 03:45:41 AM »

Hello people,

I want to ask if you can help me to detected where is my problem or mistake that cause this vibration and noise at low speed motor?

https://www.youtube.com/watch?v=CvpCPtk-x4Q

Thanks so much! 

63

General Mach Discussion / Re: speed control when cutting! please to help!

« on: February 05, 2015, 02:38:48 PM »

Thanks you so much Hood..
Can you please help me to setup my velocity and acceleration for my machine? It's so complicated!! I dont like my setup! Can please give some ideas?

64

General Mach Discussion / speed control when cutting! please to help!

« on: February 05, 2015, 01:33:40 PM »

Hello people..

I would to ask how I can control the speed motors when my machine is cutting? Its go so slowly when cutting..

thanks so much

65

General Mach Discussion / Keyboard Arrows Button Configure! Help Pls!

« on: January 25, 2015, 05:20:17 AM »

Hello people

I want to know if there are someone to tell how I can change the arrow direction on keyboard?

The forward/back buttons I need it to direct the X axis, the left/right buttons I need it to direct the Y axis.
Unfortunately they move reverse with my table :S

Thanks so much
Best regards!

66

General Mach Discussion / Re: LazyCam Demo Version!

« on: January 18, 2015, 05:26:57 AM »

I want to know how many lines I can generate with the Lazycam Beta Licensed version for plasma profile?

67

General Mach Discussion / LazyCam Demo Version!

« on: January 18, 2015, 02:44:22 AM »

Hello there,
 
Excuse me, i just have finish my CNC plasma router, and i have learnd enought about (Mach3 + Lazycam) in demo version, and i'm now want to purchase the full version for the software. but i would to ask if i have the demo version for the Mach3 with the licensed version of Lazycam Pro, how many lines i can generate for the plasma profile?
 
Thanks so much

68

LazyCam (Beta) / Re: incremental I and J not working

« on: January 04, 2015, 09:37:54 AM »

i have the same problem!
can you help us RICH?

69

General Mach Discussion / Why LazyCam Do not Generate M25 Code!! PLS HELP!

« on: January 03, 2015, 07:58:26 AM »

How I can configure my lazycam to generate M25 code when the z axis will move down? Because in my M25 file I have written a vb scripter for the probe !!

70

General Mach Discussion / FeedHold and the Relay!!

« on: December 16, 2014, 10:01:02 AM »

Hello people..

How i can configure my mach3 that when i hit feedhold button to inactive OUTPUT#1 (plasma off)?

Thanks