Messages

51

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 07, 2015, 04:22:00 AM »

I have adjusted my steps per unit very well, now i will try to change the dip switches how did you say,,

52

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 07, 2015, 04:10:22 AM »

http://www.ebay.co.uk/itm/3-Axis-TB6560-Stepper-Motor-Driver-Board-Controller-CD-/261726719197?ssPageName=ADME:X:RTQ:GB:1123

53

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 07, 2015, 03:47:47 AM »

when i press the reset button to move the axis, i hear some a small noise in the motor (before to move them) something like there are some electric pulses in the motor!

54

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 07, 2015, 03:44:33 AM »

Here the documentation for the driver

http://www.hobbycncaustralia.com/Instructions/iI7powerTB6560.htm

55

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 07, 2015, 03:43:48 AM »

Yes Hood, at high speed its more smoother.

56

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 07, 2015, 12:14:21 AM »

If I reduce it by 50% the noise and vibration will be more violence!

When I increase it more then will be more smoothly!

57

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 06, 2015, 06:05:04 PM »

I didn't know yet how to setup it exactly but I have changed something on it but futility, no good change..

58

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 06, 2015, 11:56:54 AM »

Did you have a looked at the video?

59

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 06, 2015, 11:32:22 AM »

What is the cause of noise and vibration at low speed? This is my problem. .

60

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 06, 2015, 10:18:05 AM »

Hello Hood..
Did you have looked to my machine?