Messages

41

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 11, 2015, 02:08:34 PM »

But when I have to put the active low option on my setup? Because I still hear some noise on my stepper?

42

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 11, 2015, 02:58:28 AM »

Hello people,

Can someone explain to me what it's exactly the option of step pulse and dir pulse? Excuse me but I yet beginner on the mach3 :S

Thanks so much!

43

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 09, 2015, 03:01:44 AM »

Hmm correct!
Thank you so much Hood!

44

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 09, 2015, 01:06:12 AM »

So nice people about this information! How i saw on youtube and other source information about this driver, i can say it's the best driver around world! But it's so expensive specially for me in the beigging!
I have found other driver on Ebay that appear to me it's a good! Please people, have a look to see it, may be there are something that i didnt know about it before to purshase it!

http://www.ebay.com/itm/400858402049 

Thanks you so much!

45

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 08, 2015, 06:12:04 AM »

Ok Hood, I don't know how to thank you about this amazing information.
I want to bay the drivers motor but I need you to help me which driver to choice for my motors..

46

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 07, 2015, 03:28:43 PM »

Excuse me Hood, but it's a normal thing that the axis be different mass in every table!
I didn't know what to do now! I can't know where is the problem! Or on this Chinese driver or on motor or I need to change my system to be with drivers motor! Or with my racks and pinions :S
How I see and feel, my problem will be resolved just if I connect the motors to drivers!
What you think mr. Hood?

47

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 07, 2015, 09:09:28 AM »

ok now its ok, but i can understand why my y axis its ok and more more smoother than x axis? they have the same pinions and racks and dip switches setting!

48

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 07, 2015, 04:44:23 AM »

and in the motor tuning what i need to put in the step/dir pulse?

49

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 07, 2015, 04:40:31 AM »

OK Hood, i have adjusting the 5 and 6 and its apear ok, but excuse me i didnt understand you how to know the current rating of my stepper to the dip 1 and 2?

50

General Mach Discussion / Re: Vibration At Low Speed! Help please!

« on: February 07, 2015, 04:26:31 AM »

Ok Hood, i have put 6 & 5 to off, 1 & 2 & 3 & 4 to on, yes it more smoother now, but i hear noise in the motor when it moving and stoping!