1
General Mach Discussion / converting the Proxxon Micro Miller MF70 to CNC
« on: October 29, 2014, 11:06:32 PM »
Hello Everyone,
I am a complete newbie to CNC
Recently having purchased a Proxxon Micro Miller MF70 want to convert it to 3-axis CNC.
It would be of great help if anyone could guide me in the right direction as to what to procure in order to accomplish the CNC conversion.
Here is what I plan to buy:
1 x 24V/10A switching power supply
3 x 1 Axis TB6560 stepper motor driver
3 x 57HS76 3A 270 oz/in stepper motor
1 x 5 axis Mach3 compatible breakout board
1 x DB25 parallel cable
1 x USB cable
3 x signal cables
3 X NEMA23 stepper motor mounting brackets
6 X limit switches
1 X E stop switch
3 X suitable flexible couplers
1 X Mach3 USB handwheel manual controller
Thanks in advance
I am a complete newbie to CNC
Recently having purchased a Proxxon Micro Miller MF70 want to convert it to 3-axis CNC.
It would be of great help if anyone could guide me in the right direction as to what to procure in order to accomplish the CNC conversion.
Here is what I plan to buy:
1 x 24V/10A switching power supply
3 x 1 Axis TB6560 stepper motor driver
3 x 57HS76 3A 270 oz/in stepper motor
1 x 5 axis Mach3 compatible breakout board
1 x DB25 parallel cable
1 x USB cable
3 x signal cables
3 X NEMA23 stepper motor mounting brackets
6 X limit switches
1 X E stop switch
3 X suitable flexible couplers
1 X Mach3 USB handwheel manual controller
Thanks in advance