Guest
Show Posts
1
General Mach Discussion / Circles not coming out round...
« on: October 28, 2014, 07:18:08 PM »
Hi All,
I've been using Mach3 for about 6 months now on my CNC converted mill, I seem to be having problems with my latest part getting it to produce round holes though. Here's a snipped of code I'm running:
I'm using a Ø10mm cutter, which should give a hole diameter of Ø15mm. Cutting and measuring a hole however, I get ~14.7mm in the Y direction, and ~14.3mm in the X direction. That latter value seems too far under to be just a backlash issue (I've measured backlash to be about 0.06mm in both axes, which I've tuned out with backlash compensation), I'm suspecting something's up with my Mach3 setup. Any ideas?
Thanks for any help.
I've been using Mach3 for about 6 months now on my CNC converted mill, I seem to be having problems with my latest part getting it to produce round holes though. Here's a snipped of code I'm running:
Code: [Select]
G71
S2100 M03
G01 G43 X34 Y-25 Z2 F800 H12
Z-11.5 F174.4
X31.5
G03 X31.5 Y-25 I2.5 J0
G01 X34
Z2 F800
M30I'm using a Ø10mm cutter, which should give a hole diameter of Ø15mm. Cutting and measuring a hole however, I get ~14.7mm in the Y direction, and ~14.3mm in the X direction. That latter value seems too far under to be just a backlash issue (I've measured backlash to be about 0.06mm in both axes, which I've tuned out with backlash compensation), I'm suspecting something's up with my Mach3 setup. Any ideas?
Thanks for any help.