Hello Guest it is June 16, 2019, 03:45:20 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - vw_man99

Pages: « 1 2 3
21
Hi All,
Looking at several threads about the CSMIO/IP-A (most with Hoods great feedback) I am just about ready to order. I have worked with typical step/dir steppers with LinuxCNC in the past but am still unsure how to connect Mitsubushi MR-J2S-40A in speed mode with pins ST1 (CCW)/ST2 (CW) to the controller and configure in Mach. Have most of my pin layout for the 4-axis mill conversion planned out. Has anyone used the Mitsu controllers with CSMIO IP-A? Any diagram/layout you can share?
Thanks.

vw

Pages: « 1 2 3