Messages

171

Mach4 General Discussion / Re: Mach4 build 3390 - Keyboard Inputs

« on: June 09, 2017, 07:28:50 AM »

Glad you have it sorted

Allan

172

Mach4 General Discussion / Re: Mach4 build 3390 - Keyboard Inputs

« on: June 08, 2017, 09:32:29 AM »

Try using the keyboard plugin from version 3233. This worked for me.

Allan

173

Mach4 Videos / Re: Basic Modules Mach4

« on: May 29, 2017, 07:01:16 AM »

Very informative Daz. Thanks for shining a light into some of the corners of all this stuff.

Allan

174

Mach4 General Discussion / Re: How to use the keyboard ESC key to stop all movement.

« on: May 23, 2017, 03:14:15 PM »

I suggest you substitute mc.mcCntlCycleStop (inst) for mc.mcCntlFeedHold (inst)
in the code for Input63. If this works then something must be mismatched in the Keyboard plugin / Input Signals area for Input62.

By the way, Daz is right, though either way should work .

Allan

175

Mach4 General Discussion / Re: How to use the keyboard ESC key to stop all movement.

« on: May 23, 2017, 10:48:21 AM »

OK.  I can't see a problem with the script itself. Let's go to the next step.

Have you set up an entry (or checked that one exists) in the Keyboard plugin and assigned this to Input 62 in Mach4's Input Signals tab?

Allan

176

Mach4 General Discussion / Re: How to use the keyboard ESC key to stop all movement.

« on: May 22, 2017, 06:02:30 PM »

Why  are you showing the second section as  all commented  out? What code are you actually using?

Allan

177

Mach4 General Discussion / Re: How to use the keyboard ESC key to stop all movement.

« on: May 22, 2017, 07:31:12 AM »

Check your capitalisation in mcCntlCycleStop. Upper and lower case C look similar.

Allan

178

Mach4 General Discussion / Re: Probing Question PoundVar 5062 amd 5072

« on: May 01, 2017, 03:41:27 PM »

Steve, I see where you're coming from. . Thanks for that clarification.

Allan

179

Mach4 General Discussion / Re: Probing Question PoundVar 5062 amd 5072

« on: April 30, 2017, 04:39:11 PM »

506x are the user coordinates. I'm not sure whether these relate to G54 or whether the current fixture offset is used - I have only tested with G54.

507x are the machine coordinates. I agree that the probing module is confusing.

Allan

180

Mach4 General Discussion / Re: Probing Question PoundVar 5062 amd 5072

« on: April 30, 2017, 03:34:17 PM »

Steve

These come from the probing module and appear to be borne out when using it with Probe (G31.0).

Allan