Messages

41

General Mach Discussion / Re: Mach3Mill.xml still being over written with updates

« on: October 14, 2006, 06:51:06 AM »

Brian or Art,
this is the pop-up I get when updating.
then my original Mach3mill.xml is over written with the default one.

42

General Mach Discussion / Re: inserting pics in post

« on: October 14, 2006, 06:46:00 AM »

great, thanks guys

43

General Mach Discussion / Re: inserting pics in post

« on: October 14, 2006, 06:45:16 AM »

see if this works

44

General Mach Discussion / inserting pics in post

« on: October 13, 2006, 03:47:06 PM »

can someone tell me how you insert a photo into these posts? I see several posts with pict download buttons but cannot tell how its done.
thanks,
Chuck

45

General Mach Discussion / Re: LPT woes

« on: October 13, 2006, 01:40:25 PM »

I think the 3.3V would effect the outputs more than the switch inputs. the motor signals are working which shows enough is being output to drive the controller.
can you see any switch activity on the diagnosis screen?

46

General Mach Discussion / Mach3Mill.xml still being over written with updates

« on: October 13, 2006, 01:17:15 PM »

Mach3Mill.xml is still being over written when I install the latest updates to Mach 3. this did not happen before versions "RC"
does this need to happen? sounds petty but curious what changed.

also is it necessary to reboot when doing upgrade or just on new install?

47

General Mach Discussion / Re: RC2.0c rewriting XML file

« on: September 28, 2006, 01:27:35 PM »

Brian,
not really a problem but thought you might want to know.
since your not busy anyway. LOL
2.0d did the same thing. a message box pops up saying "custom setup mach3mill.xml copied to folder" but it is the default xml not the custom one created from the previous install.
chuck

48

General Mach Discussion / RC2.0c rewriting XML file

« on: September 26, 2006, 03:14:06 AM »

I just installed MACH 3 V RC2.0c and it over wrote my old mill XML  file.
 is there some reason this needs to happen? I had my old XML backed up can I use it with the new ver or do I have to re do all the settings?
chuck

49

Tangent Corner / Re: Urgent help needed.

« on: September 24, 2006, 11:52:50 PM »

your a sick man Benny!!!  and Chad, well nuff said  LOL

50

Newfangled Solutions Mach3 Wizards / Re: Surfacing wizzard- just not getting it. Brian?

« on: September 19, 2006, 11:16:15 PM »

any Gurus out there agree or disagree with the crap I've been spouting??