Messages

31

General Mach Discussion / Re: License file not working in v2.0.0.11

« on: November 20, 2006, 10:39:24 AM »

Thanks,
it works
chuck

32

General Mach Discussion / License file not working in v2.0.0.11

« on: November 20, 2006, 09:07:46 AM »

Brian,
just upgraded to V2.0.0.11 and it comes up as demo ver, copied lic files to Mach dir with no luck also NS shows un-licensed also

33

General Mach Discussion / Re: Lost my orientation...

« on: November 20, 2006, 08:21:15 AM »

Graham,
nice, but here in the States we have a similar rule with the left hand but you roll the thumb and first finger inward and stick it out the car window. LOL

34

General Mach Discussion / Re: What size power supply should I use?

« on: October 30, 2006, 03:20:35 PM »

Carl,
the voltage limit is determined by the max voltage of the GECKO drivers not the motors.
the power supply  AMPERAGE can be as high as you want as long as it is high enough to supply the max current of all the motors together.
remember you can not have too many AMPS AVAILABLE  but your VOLTAGE  must NOT be higher than the GECKO drivers can handle.
Chuck

35

General Mach Discussion / Re: problem with V2.0004

« on: October 25, 2006, 11:42:01 AM »

Art,
todays ver works great, thanks.
while I got your attention why does my mach3mill.xml file get over ridden when I upgrade ever since ver2? it did not do this before Ver2.
chuck

36

General Mach Discussion / Re: problem with V2.0004

« on: October 25, 2006, 10:54:41 AM »

Art,
0005 has the same problem.
chuck

37

General Mach Discussion / Re: problem with V2.0004

« on: October 25, 2006, 12:10:34 AM »

Brian,
here is the whole code -all was created with NS wizards key way and cut rectangle.
thanks,
chuck

38

General Mach Discussion / Re: problem with V2.0004

« on: October 24, 2006, 06:53:19 PM »

actually that was the first thing I checked because it burnt me one time before.
thanks Hood

39

General Mach Discussion / problem with V2.0004

« on: October 24, 2006, 06:12:24 PM »

Brian,
I did a clean install of V2.0004 and loaded a small part and the leadout is goofy
I reinstalled V2.000 and it is ok-- see picts
any ideas nothing else changed same xml.
chuck

40

General Mach Discussion / Re: Mach3Mill.xml still being over written with updates

« on: October 14, 2006, 07:23:39 AM »

yep, its named mach3mill.
this just started happening with the "rc" versions .
I have been updating since ver 1.83.011 and did not happen before.
I know Brian has been really busy with real problems. I am just one of those pains that needs to know why. like a 3year old LOL