Messages

21

Third party software and hardware support forums. / Re: Microkinetics and Mach3

« on: October 08, 2014, 02:37:30 PM »

Old post worth a bump...

22

General Mach Discussion / Re: Microkinetics MN400 Plugin... Or Go to Breakout Board?

« on: October 08, 2014, 03:08:24 AM »

Thanks will be looking into a plugin are there any tech doc's for a place to start?

23

General Mach Discussion / Re: Microkinetics MN400 Plugin... Or Go to Breakout Board?

« on: October 02, 2014, 06:16:12 AM »

It connects via USB or Serial... http://www.microkinetics.com/index.php?page=motionc

I am seriously thinking of just getting a breakout board and wiring it up to simplify things.

Any recommendations on a breakout board I will need 3-axis ?

24

General Mach Discussion / Microkinetics MN400 Plugin... Or Go to Breakout Board?

« on: October 01, 2014, 07:06:08 PM »

I was wondering if anyone has made a Plugin for the Microkinetics MN400 Controller?

Would like to use the controller I have but willing to switch to a breakout board.

If No plugin is Available anyone recommend a Breakout Board?

Will be using the Microkinetics Drive Rack With the DR8010 Drivers?

Photo Of My 12X36 CNC Project Lathe Attached!