Topics

1

LazyTurn / Why does my finish pass seem to cut into the profile?

« on: August 03, 2015, 06:18:31 PM »

I am trying to learn LT and Mach Turn, I've been using the wizards in Mach Turn but would like to be able to post and load gcode of some more complicated profiles.
See the screen cap.
Sorry if this is covered somewhere, I have been reading posts for two days now and can't find anything on it.
Thank you,
Gerry

2

General Mach Discussion / How do I set the tool change location in Mach3 Turn

« on: February 25, 2015, 01:13:44 PM »

Do I need to do it in Mach3 Mill, settings page and somehow copy it over to Turn?
Right now some tools are not clearing the stock for a tool change.  It seems to just go to the last position of the last cut?
Thanks,
Gerry

3

General Mach Discussion / Setting up limit/home switches for lathe

« on: February 07, 2015, 11:27:37 AM »

Hello,
Sorry if this has been covered.  Tried to search but I'm finding mostly info on mill setups and I want to make sure I understand it for my lathe.
I have image showing how I think the switches should be wired with the C10 BOB.  I also have a screen cap of the ports and pins dialog.
I'm not sure about what to put in the boxes under the columns for port# and pin#.
Can some one take a look and let me know if I am on the right track?

In addition, can I use the E-Stop on my G0602 lathe has an E-Stop for both the lathe spindle and the stepper motors by adding the wires to the C10?
Thanks,
Gerry