Messages

21

PoKeys / e-stop assign to 5 pins

« on: October 06, 2015, 02:16:27 PM »

I have 5 leadshine em806 stepper drivers. They work great. I have wired their alarm/fault signal ( if stepper looses step driver goes in to fault condition) on pin34 pin36 pin38 pin 40 and pin42. They set as input and mach3 plugin pokeys mapping they are signed to estop input. Now, if more then one of these pins are signed to e-stop function not working. If for example estop marked only at pin34 mach goes to estop when driver enables fault signal.so my question is what can i do in order to use this function to work on rest of the 4 pins?

22

Brains Development / Re: Machine status light

« on: October 04, 2015, 11:29:26 AM »

Thank you alan, but i don't have this device. I have a pokeys56U

23

Brains Development / Machine status light

« on: October 04, 2015, 09:43:40 AM »

Good Morning to all. Today i could write a brain which enables a green led when g code running, BUT I need a little help from someone who could help me to write a brain which triggers an outpout when i press feedhold on mach3 and than this output would flash the yellow led on my machine stack light. Also another brain for when i click on stop, machine's Red  led active and when reset e-stop clicked red led is flashing.

Thank you in advance

24

Brains Development / combined auto Z zero macro for cnc plasma

« on: September 10, 2014, 11:36:33 AM »

Hallo to all. I have a question to the experts in macro. So i would like is when an external switch triggered,  this macro would be activated.  In macro what i need is this: G0 IZ15 and than G92 Z0. How to write that for a dro and place it on the screen? And than assign the switch to it?  Thank you.