Hello Guest it is March 29, 2024, 09:19:57 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - johndolecki

Pages: « 1 2 3 4 5 6 7 8 »
41
Modbus / Re: Who can I call to help me setup this automation direct vfd
« on: November 04, 2017, 07:50:27 PM »
Here is the error code ce02 and 3

42
Modbus / Re: Who can I call to help me setup this automation direct vfd
« on: November 04, 2017, 07:39:22 PM »
Sorry bad info
As soon as I enable modbus  run my drive faults out

43
Modbus / Re: Who can I call to help me setup this automation direct vfd
« on: November 04, 2017, 07:18:45 PM »
When I type m3 in mdithe drive faults

44
Modbus / Re: Who can I call to help me setup this automation direct vfd
« on: November 04, 2017, 07:14:03 PM »
I have a lot of it it just don't work

45
Modbus / Re: Who can I call to help me setup this automation direct vfd
« on: November 04, 2017, 07:05:39 PM »
When I type m3 my drive faults with a ce02
I don't see that screen

46
Modbus / Who can I call to help me setup this automation direct vfd
« on: November 03, 2017, 07:53:15 PM »
I have been trying and I just can't figure it out
Who can I call to help me set this spindle control tru modbus?

I have a automation direct gs2 vfd.
I also have the USB to 485 from automation direct.

I looked at Most of the post on the internet but no just can't get it.

Thanks in advance.

47
Bargain Basement / Re: Give Away Chicago Area
« on: October 31, 2017, 07:47:33 PM »
Please post pictures or pm them to me

48
Bargain Basement / Re: Give Away Chicago Area
« on: October 31, 2017, 07:33:26 PM »
It's free right?

49
Bargain Basement / Re: Give Away Chicago Area
« on: October 31, 2017, 05:54:32 PM »
Did u give this away already?
Pictures?

50
SmoothStepper USB / Happy with my ess
« on: October 31, 2017, 05:47:18 PM »
Had it for a while and starts up every time with no issues
Installing the drivers / plug ins was easy to.
Great product

Will it work with mach4 ?

Pages: « 1 2 3 4 5 6 7 8 »