Hello Guest it is March 29, 2024, 02:53:11 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - johndolecki

Pages: « 1 2 3 4 5 6 7 8 »
11
General Mach Discussion / Changing computers and moving the license
« on: March 30, 2018, 06:06:27 PM »
I'm changing computers my old computer has the license on it

How do I get it to my new computer.

Also I running unlicensed on my new computer to set up the I/O I have a Ethernet smooth stepper.

Will the demo still generate motion signals cause I can't se m to get any movement when I try to jog the machine.

I know I read about moving the license but I can't seem to find that post anywere.

12
Show"N"Tell ( Your Machines) / Re: new control panel
« on: March 21, 2018, 07:19:17 AM »
It's a Bridgeport Series 1 R2E3

When i got it the DC power supply was shorted. So i replaced everything with new controls but keep the Factory DC servos.

Ethernet Smooth stepper, CNCDrives servo drivers, 80 volt DC power supply. AMT-102 encoders. Used the factory enclosure and servo cables.
Automation direct VFD single phase to 3 phase so I'm using the original motor.



13
Show"N"Tell ( Your Machines) / Re: new control panel
« on: March 20, 2018, 07:55:34 AM »
Started moving the buttons around in Mach 3. i started with the factory  1024 screen set.

My workstaton is a board on to of a garbage can.

Do know why the pictures dont post in proper position??

14
Show"N"Tell ( Your Machines) / Re: new control panel
« on: March 12, 2018, 03:15:29 PM »
Mach3 seems to conform to the vertical screen. but the boxes need some resizing.

I don't thing the touch screen likes windows xp as its acting goofy

probably gonna switch computer to something more sutable to mach 4

first picture is suppose to be vertical??

15
Show"N"Tell ( Your Machines) / Re: new control panel
« on: March 07, 2018, 08:34:41 AM »
Here I'm milling the button holes.

16
Show"N"Tell ( Your Machines) / Re: new control panel
« on: March 07, 2018, 08:13:45 AM »
I dont know why the picture didn't appear in the vertical position? I can seem to change it

17
Show"N"Tell ( Your Machines) / new control panel
« on: March 07, 2018, 08:07:25 AM »
uses a 22.5 inch touch screen

18
I have just started learning mach4 screen designer.
I have a 23 inch touch screen in portrait mode
How do I Change the screen size and orientation so I can design the screen in the correct size?

I hope that made sense?

Thank, john

19
Modbus / Re: Who can I call to help me setup this automation direct vfd
« on: November 16, 2017, 12:21:31 PM »
I was never going to buy that machine I just think the touch panel control is the way to go

20
Modbus / Re: Who can I call to help me setup this automation direct vfd
« on: November 16, 2017, 09:31:42 AM »
joeaverage has inspired me to build a new control using mach4 here is the start of it

Pages: « 1 2 3 4 5 6 7 8 »