21
Mach4 General Discussion / Egg shaped holes
« on: June 04, 2016, 12:12:28 AM »
I'm getting egg-shaped holes when pocket milling with Mach 4. The holes are 3 mil out of round. Using Mach 3 I got only 1 mil out of round. The holes in Mach 4 are also undersized about 10 mil (average). Mach 3 always came out right on size.
Such a weird problem. Is anyone else seeing this? Could it be the backlash parameter is not being implemented correctly in Mach 4? I'm using the same backlash value on both programs.
Such a weird problem. Is anyone else seeing this? Could it be the backlash parameter is not being implemented correctly in Mach 4? I'm using the same backlash value on both programs.