1
Promote and discuss your product / Re: Free G76 Macro Helping program for Mach3 Turn
« on: February 29, 2020, 03:51:54 AM »
It should have the -6 at the very end of the pullout. I did that to prevent collisions if you have a tiered bolt (and it was so originally). So if you have 360 degrees pullout, you have to add a full pitch to get the length of full thread you want.
The 5 - something is around three pitches run-up to stabilize the sync between spindle and Z-axis. The parallel port takes longer to stabilize than the Smoothstepper, so i made that an option (smoothstepper is one pitch plus clearance).
The 5 - something is around three pitches run-up to stabilize the sync between spindle and Z-axis. The parallel port takes longer to stabilize than the Smoothstepper, so i made that an option (smoothstepper is one pitch plus clearance).