1
General Mach Discussion / Re: G Code movement interrupted by an input.
« on: August 24, 2014, 08:23:01 PM »
>Of just a single axis? Or all? And why?
For all axis. It is a pick & place machine resolved by CNC: MACH3, AKZ250, Delta Servo drivers & motor.
>And why?
I need to change the movement in answer to a proximity sensor signal mounted in the hand.
For all axis. It is a pick & place machine resolved by CNC: MACH3, AKZ250, Delta Servo drivers & motor.
>And why?
I need to change the movement in answer to a proximity sensor signal mounted in the hand.