Guest
21
Mach SDK plugin questions and answers. / Re: Impact engraving plugin
« on: January 30, 2017, 12:49:20 PM »
Will talk to him and ask if he allows
Hello Guest it is April 25, 2024, 02:36:17 AM
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
in my machine before i start a work the lever goes down.I guess its because i have set the output as high ,so whem the axis start it could scratch the workpiece.Só i use the Spring to reinforce ig up.In the new head i took it offAnd how are they better than a spring?Instead of a Spring pushing the Lever, you have 4 Magnets Two in the Lever and two more in the base each oposing another letting the lever float , when you give the impact it resists and send it Back up , when the other magnet stops it and so on
Dan
Hi Jan,
Thanks for explaining. In your video I can see a spring there as well - what is its purpose?
Dan
And how are they better than a spring?Instead of a Spring pushing the Lever, you have 4 Magnets Two in the Lever and two more in the base each oposing another letting the lever float , when you give the impact it resists and send it Back up , when the other magnet stops it and so on
Dan
Neodimium magnetsWatch how my solenoid was made.I guess the mechanical design is a must.In some works I can go up to 10.000, but in others at 10000 it will leave traces between two dots.
I absolutely agree with you about this. In the video it there is no enough information to understand how the solenoid was made. Also what did you use for the coil?
Dan