Messages

71

General Mach Discussion / Re: CS Labs CSMIO/P-A

« on: August 21, 2018, 04:58:40 PM »

Hi Craig

Yes, you are right. Looks like an SCSI connector. I don't think I cant use that pre-wired connector. The data sheet shows different twisted pairs combinations to what comes out the servo drive? 

Cheers

72

General Mach Discussion / Re: CS Labs CSMIO/P-A

« on: August 21, 2018, 03:12:53 PM »

Hi Craig

The picture I sent was the drive. The connection is receptacle on the drive. Just looking at your link.

Cheers

73

General Mach Discussion / Re: CS Labs CSMIO/P-A

« on: August 21, 2018, 02:11:03 PM »

Hi

Picture attached.

Two rows of pins.

Cheers

74

General Mach Discussion / Re: CS Labs CSMIO/P-A

« on: August 21, 2018, 01:58:24 PM »

Hi Craig

I'll try searching that.

The screws to hold it in are 47mm apart. It only has 2 rows of pins unlike the standard SUBD 50 which has three. Searching RS components who sell everything but still struggling.

These will be a pain in the A*** to solder.

Cheers

75

General Mach Discussion / Re: CS Labs CSMIO/P-A

« on: August 21, 2018, 01:35:15 PM »

Hi All

Any idea where to buy the D SUB 50 connectors? Ordered genuine ones from Schneider with pre-attached cables who are now saying they are made to order with no guaranteed lead time. They are not the standard DSUB 50 connectors. They are about half the size. I can't find any more info in the manual except DSUB 50

Cheers
Mick

76

General Mach Discussion / Re: CS Labs CSMIO/P-A

« on: August 20, 2018, 03:58:20 PM »

Hi Hood

Cheers for the link. I've ordered the one from Schneider now. Along with the CN1's that didn't arrive.

Mick

Craig

I took your advice on the flowers and she's pricing the spindle drive and motor in the morning. Lmao

77

General Mach Discussion / Re: CS Labs CSMIO/P-A

« on: August 20, 2018, 03:14:15 AM »

Lol
Your a funny guy.

Cheers

78

General Mach Discussion / Re: CS Labs CSMIO/P-A

« on: August 19, 2018, 03:29:39 PM »

Hi
Yes will do but everything is a 6 working day lead time with this stuff.
Will have a dabble in the mean time.
There are loads of rj45 to usb converters freely available on the net. Would these be a standard cable? Or would I need the genuine one?&
Cheers

79

General Mach Discussion / Re: CS Labs CSMIO/P-A

« on: August 19, 2018, 12:03:24 PM »

Hi Craig

Yes, I do have the software installed but unfortunately, I didn't get the RJ 45 to USB converter cable. Reading up you can do most of the stuff direct from the Drives control panel. I've been looking at the scaling information which is confusing me slightly at the moment.   

Cheers
Mick

80

General Mach Discussion / Re: CS Labs CSMIO/P-A

« on: August 18, 2018, 01:26:24 PM »

Hi Craig

Ok I think that makes sense. I will be using the same 24v power supply so this shouldn't be an issue. I really need to do some more research on the difference between GND, COMMON, 0V.

Cheers
Mick