Hello Guest it is January 16, 2022, 05:51:21 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - idekkers

Pages: 1
General Mach Discussion / setup questions from newbe
« on: June 20, 2014, 04:52:25 PM »
Hey there

I'm setting up my first CNC machine, and I have a few questions I hope you can help me with:

my setup is this:
Drivers: http://www.wantmotor.com/ProductsView.asp?id=257&pid=82
PS: http://www.aliexpress.com/store/product/Best-Selling-Wantai-Single-Output-Power-Supply-350W-36V-S-350-36-for-CNC-Router-Grind/511874_677179176.html
motors: http://www.wantmotor.com/ProductsView.asp?id=160&pid=80 the 57BYGH115-003 (second from bottom)

so my 2 questions are:
1. how do I set the jumpers on the drivers ?
2. I see 2 setups for the wires from the pul and dir pins - one is to connect the positive pins to the BOB power supply +5 and the 2 negative to the BOB control pins,
and the other is to connect the negative to ground of the BOB and the positive to the control pins.
does it matter which setup?

thanks so much for your help

Pages: 1