Topics

1

General Mach Discussion / I have a new xp computer

« on: August 01, 2014, 11:11:42 PM »

This is a new xp computer that i will use only for cnc routing. It does not have access to the internet. I want to purchase Mach3 with my computor that access's the internet but does not have a serial port like the xp computer which i need to run Hobby cnc.After purchase can i down load mach3 to a thumb drive and install it on the xp or is it only good to run on the downloading computer ?

2

FAQs / new to cnc

« on: June 20, 2014, 02:51:22 PM »

will Mach3 work with a HOBBYCNC control board hardware which use 205 oz stepper motors ?