Hello Guest it is March 28, 2024, 02:22:03 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mrputz1

Pages: 1
1
General Mach Discussion / Re: I have a new xp computer
« on: August 02, 2014, 10:08:59 AM »
Thank you so much . I am new and going to build a cnc router, I did not want to purchase the software if i could only use it on one computer.

2
General Mach Discussion / I have a new xp computer
« on: August 01, 2014, 11:11:42 PM »
This is a new xp computer that i will use only for cnc routing. It does not have access to the internet. I want to purchase Mach3 with my computor that access's the internet but does not have a serial port like the xp computer which i need to run Hobby cnc.After purchase can i down load mach3 to a thumb drive and install it on the xp or is it only good to run on the downloading computer ?

3
FAQs / Re: new to cnc
« on: June 21, 2014, 11:12:03 AM »
Thank you very much . I have the the board and stepper motors and they are unipolor.

4
FAQs / new to cnc
« on: June 20, 2014, 02:51:22 PM »
will Mach3 work with a HOBBYCNC control board hardware which use 205 oz stepper motors ?

Pages: 1