Messages

31

One on one phone support. / Re: Need Help. Motors not responding.

« on: July 12, 2014, 11:07:07 PM »

that plug is for the probe

32

One on one phone support. / Re: Need Help. Motors not responding.this is key

« on: July 12, 2014, 12:23:00 AM »

Thanks everyone. Rich, Tweakie, and Ian. Ok here's the solution. First off Rich thanks for the pdf of my machine. I uninstalled everything following the pdf I reinstalled mach 3 and reconnected all the cables to my cnc 3020t and than I went to the settings and enabled on output signals port 1 pin 14 active high. Than I went to motor tuning and setup x and y to steps 400, velocity 2000, acceleration 200, step pulse to 10, and direct pulse to 3. Than Z is steps 400, velocity 800, and acceleration 100, step pulse 10 and direct 3. Now it works. Ok rich or anyone now that I've done this can someone please tell me how to cut my first board like setting home position and getting g code and how to set Z clearance and how to cut my first piece. Thanks everyone.

I have had the same problem.enabled output signals port 1 pin 14 active high. and it fixed the problem