Messages

21

General Mach Discussion / Re: 3020t problem

« on: July 29, 2014, 03:11:04 AM »

OK will do in the morning
 Thanks Mike Irvin

22

General Mach Discussion / Re: 3020t problem

« on: July 29, 2014, 02:09:23 AM »

Ok thanks but i have nothing but problems i changed computers configured mach3 and now i have movement on all  x  y  and z . but when i move z with keyboard keys i get no dro movement any ideas
Mike Irvin

23

General Mach Discussion / Re: 3020t problem

« on: July 28, 2014, 04:55:39 PM »

yes the image that shows while mach is loading to the select profile it changer every time

24

General Mach Discussion / Re: 3020t problem

« on: July 28, 2014, 04:49:12 PM »

windows xp 5.1
The time shows the last  "save settings"

25

General Mach Discussion / Re: 3020t problem

« on: July 28, 2014, 03:43:54 PM »

It is updating the time at every "save settings". question should i be getting a different splash screen every time i start mach3

26

General Mach Discussion / Re: 3020t problem

« on: July 27, 2014, 08:18:07 AM »

1  Start program   max nc 10 unchecked      not working
2  check max nc          not working
3  restart mach3   max nc checked       not working    dro's move steppers  x y  make a noise  but not Z
4  uncheck max nc       all  works fine    but need to re assign home switch pin numbers  the limit switches are ok
5  close mach3 and restart 100 times   working
6  reboot computer   Not working
This happens on both computers  One a dell and a gateway and always did .

 the editor i now understand  Thanks

27

General Mach Discussion / Re: 3020t problem

« on: July 26, 2014, 09:30:05 PM »

something is wrong i just hit edit gcode and all it dose is regen dose not open the editor
i tried what you said and that makes it work but a reboot kills it

28

General Mach Discussion / Re: 3020t problem

« on: July 26, 2014, 07:43:28 PM »

ok thanks also i renamed after copying it not the original
Mike 

29

General Mach Discussion / Re: 3020t problem

« on: July 26, 2014, 07:34:19 PM »

the mike1.xlm  lets me run ok i rebooted and that is mike.xlm not working
Mike

30

General Mach Discussion / 3020t problem

« on: July 26, 2014, 06:42:17 PM »

I need help i can setup and run but as soon as i reboot i have to reset up the home switches  go to configure ports and pins "check" MAX nc 10 shut down the program restart mach3 go to configure ports and pins "UNcheck" MAX nc 10. then everything is ok this happens on all my computers i tried.  this is a LICENSED copy of MACH3
Mike