Messages

11

General Mach Discussion / Re: Heeeeeeeelllllpppp

« on: September 15, 2014, 07:26:21 PM »

i may be able to help what are your problems
Mike Irvin
l

12

General Mach Discussion / Re: Do I have a problem

« on: September 07, 2014, 05:16:03 PM »

same here .hope to get a reply

13

General Mach Discussion / Re: dumb question

« on: September 07, 2014, 01:49:01 AM »

Thanks for the info
Mike Irvin

14

General Mach Discussion / dumb question

« on: September 06, 2014, 10:23:55 PM »

If you scale down a drawing "mach3" scale do you have to scale down the end mill also.
Mike

15

General Mach Discussion / Re: No Motor Movements -- Newbie

« on: September 04, 2014, 04:47:49 PM »

mine is    enable1    port 1 pin 14 active low took me 6 months to get it as it was not in the destructions
Mike

16

General Mach Discussion / engrave on a bat

« on: August 27, 2014, 05:05:45 PM »

Anyone know of software to engrave on a bat  without a 4th axis

17

General Mach Discussion / Re: Homing Switch is switched on how do I reverse this

« on: August 10, 2014, 02:25:59 PM »

if i understand you .then you go to ports and pins and change it from active low to active high
Mike

18

General Mach Discussion / Re: How do you alter the number of decimal places the DROs show?

« on: August 09, 2014, 12:26:06 PM »

Thank You. And will it let me change any screen set
Mike

19

General Mach Discussion / Re: How do you alter the number of decimal places the DROs show?

« on: August 09, 2014, 12:11:09 PM »

where do i find Screen4 designer

20

General Mach Discussion / 3020t-d PWM

« on: August 02, 2014, 01:51:46 PM »

Any one have info on the PWM on this controler it has two boards and both have connectors that say PWM
Thanks Mike