Hello Guest it is March 29, 2024, 08:26:34 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Mike Irvin

Pages: 1 2 3 4 »
2
Set up "enable 1"  to pin   14 port 1
Mike Irvin

4
General Mach Discussion / Re: HELP...this poor girl is clueless!
« on: September 19, 2014, 03:46:53 PM »
i just sent you an email
Mike

5
General Mach Discussion / Re: HELP...this poor girl is clueless!
« on: September 19, 2014, 03:30:52 PM »
I can help have you set up the machine as per the instructions

6
General Mach Discussion / Re: Heeeeeeeelllllpppp
« on: September 16, 2014, 04:11:09 PM »
Send me the v carve drawing file for the circle you are trying to cut  i will forward it to my friend and he will look at it
Mike Irvin

7
General Mach Discussion / Re: Heeeeeeeelllllpppp
« on: September 16, 2014, 02:31:37 PM »
LostInTranslation  did you get the message i sent you about calling me
Mike Irvin

8
General Mach Discussion / Re: Heeeeeeeelllllpppp
« on: September 16, 2014, 02:21:08 PM »
I think you problem is with v carve settings i am not up on v carve as i use sharp cam and turbo cad i will get a friend who is good with it to try and get you an answer






9
General Mach Discussion / Re: Heeeeeeeelllllpppp
« on: September 16, 2014, 01:47:13 PM »
Is mach3 set to 1.000 on all the scales

10
General Mach Discussion / Re: Heeeeeeeelllllpppp
« on: September 16, 2014, 01:29:59 PM »
set  v carve material setup make sure material is 24 x 24 or larger make sure datum position is set  to  x0 y0  NOT center  make sure  "use offset" is unchecked
Mike Irvin

Pages: 1 2 3 4 »