Messages

51

General Mach Discussion / Re: phase converter error when I stop spindle <<HELP

« on: May 22, 2014, 05:13:18 AM »

I will have to adjust after all . Fail

52

General Mach Discussion / Re: phase converter error when I stop spindle <<HELP

« on: May 19, 2014, 04:52:07 AM »

I think I figured it out. I think it was my pulley configuration .

53

General Mach Discussion / Re: phase converter error when I stop spindle <<HELP

« on: May 17, 2014, 09:32:51 PM »

Thanks

54

General Mach Discussion / Re: computer crashed need HELP!!! transfering data

« on: May 17, 2014, 08:07:31 AM »

we have it up and running now !!! I put all file in my c drive but never installed the drivers   what was I thinking LOL

55

General Mach Discussion / phase converter error when I stop spindle <<HELP

« on: May 17, 2014, 08:06:18 AM »

If I am doing manual work and I shut off the spindle the phase converter errors out making me go behind the machine and hit the rest button . not sure if this was an issue with the old owner as he had a different converter on it . long story short the old owner switched it to a single phase so I could run it in my garage )

any and all help is greatly appreciated

56

General Mach Discussion / Re: hand controllers which is best

« on: May 05, 2014, 09:00:17 AM »

Ok after a quick search YouTube has me going fine with the express. I will use that for a while and go from there . Damn the keyboard was rough lol since I am used to big mills with controllers lol

57

General Mach Discussion / Re: hand controllers which is best

« on: May 03, 2014, 10:11:48 AM »

I have a shuttle express that came with the mill but I can't find the proper plug in for it on the mach 3 page

58

General Mach Discussion / Re: computer crashed need HELP!!! transfering data

« on: May 02, 2014, 04:43:08 AM »

Problem solved!! The original owner came by last night and we tested things for a couple hours  and had to install the software . And run a couple of new wires .!!!!!  now time to wrap things up so I can start cutting .  Thanks for all the replies

59

General Mach Discussion / Re: hand controllers which is best

« on: May 01, 2014, 04:33:04 PM »

Yeah I am a cnc operator / programmer by trade so I'm just starting out with this ih cnc . Once I get it going

60

General Mach Discussion / Re: computer crashed need HELP!!! transfering data

« on: May 01, 2014, 12:35:56 PM »

well the owner had an unexpected thing pop up and said he may be able to come by today.

I am thinking I need to replace the logics wire that runs from the control to the phase converter. does anyone know what wire I should be using ?