Hello Guest it is January 27, 2022, 10:15:14 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - gnomic

Pages: 1
Newfangled Solutions Mach3 Wizards / Re: Gear Cutting with 4th Axis
« on: November 14, 2016, 06:33:17 PM »
I must be a moron but in the gear cutting wizard, which number do you use to cut blank from the right (behind).
What settings would you use to cut 1 inch blank with 30 gears. Going right to left from the back.

Trying to set up steps. Units set to inches. If I put in 1" it moves about 1/20. If I put in 20 it moves one inch? Yes I am a moron. Any info. Appreciated.

Pages: 1