Messages

11

FAQs / Re: Zero tool height.

« on: March 03, 2014, 11:39:18 AM »

As a J3 flyer in 1958, thank you, even if it does not work. Eli

12

FAQs / Re: Mach3 4th axis question

« on: March 02, 2014, 04:48:52 PM »

Open config Ports and pins go to Y and change the red X to a green check  then go to slave axis then make sure you click on A then OK make sure your Y and A are running at the same speed. Eli

13

FAQs / Re: Zero tool height.

« on: March 02, 2014, 04:05:27 PM »

I set my machine for plasma and router. I also have a Z height problem. I know "0" about "G"code. I have a G540 with 4 outlets, 3 of which are used by limit switches and I need to Z the tool height and then set the edges of the starting corners. I'm 80 and have been working on my machine for 2 years. Two heart attacks and several strokes have not stopped me from cutting my first piece. I soldered a wire from my only open inlet to a flatened penny and ground the bit that when I make contact reads 1-12 but when I click on the flashing "auto tool zero", it reads not yet implementd. I hate to take the machine with me if it does not work.